[flashrom] [PATCH 1/1] Mark Gigabyte GA-6ETXDR as UNSUPPORTED so far
Peter Lemenkov
lemenkov at gmail.com
Wed Jun 2 20:25:31 CEST 2010
Here is a short flashrom log:
dev ~ # ~petro/flashrom/flashrom
flashrom v0.9.2-r1025 on Linux 2.6.18-164.15.1.el5 (i686), built with libpci 2.2.3, GCC 4.1.2 20080704 (Red Hat 4.1.2-48), little endian
flashrom is free software, get the source code at http://www.flashrom.org
Calibrating delay loop... OK.
No coreboot table found.
This chipset supports the following protocols: Non-SPI.
WARNING: No chipset found. Flash detection will most likely fail.
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.
dev ~ #
Signed-off-by: Peter Lemenkov <lemenkov at gmail.com>
---
print.c | 1 +
1 files changed, 1 insertions(+), 0 deletions(-)
diff --git a/print.c b/print.c
index bf75990..bfe2dcb 100644
--- a/print.c
+++ b/print.c
@@ -334,6 +334,7 @@ const struct board_info boards_known[] = {
B("GIGABYTE", "GA-2761GXDK", 1, "http://www.computerbase.de/news/hardware/mainboards/amd-systeme/2007/mai/gigabyte_dtx-mainboard/", NULL),
B("GIGABYTE", "GA-6BXC", 1, "http://www.gigabyte.com/products/product-page.aspx?pid=1445", NULL),
B("GIGABYTE", "GA-6BXDU", 1, "http://www.gigabyte.com/products/product-page.aspx?pid=1429", NULL),
+ B("GIGABYTE", "GA-6ETXDR", 0, "http://www.gigabyte.com/products/product-page.aspx?pid=992", NULL),
B("GIGABYTE", "GA-6ZMA", 1, "http://www.gigabyte.com/products/product-page.aspx?pid=1541", NULL),
B("GIGABYTE", "GA-7VT600", 1, "http://www.gigabyte.com/products/product-page.aspx?pid=1666", NULL),
B("GIGABYTE", "GA-7ZM", 1, "http://www.gigabyte.com/products/product-page.aspx?pid=1366", "Works fine if you remove jumper JP9 on the board and disable the flash protection BIOS option."),
--
1.7.0.1
More information about the flashrom
mailing list