[flashrom] VIA VT6421A (HZ-006)

[Roy]

Hi all,

It has "HZ-006" printed on the PCB. It does have Pm39LV512-70JCB on the  
board, but it seems no firmware written and no boot ROM messages.

lspci:
00:0f.0 RAID bus controller [0104]: VIA Technologies, Inc. VT6421 IDE RAID  
Controller [1106:3249] (rev 50)
	Subsystem: VIA Technologies, Inc. VT6421 IDE RAID Controller [1106:3249]
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-  
Stepping- SERR- FastB2B- DisINTx-
	Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-  
<MAbort- >SERR- <PERR- INTx-
	Latency: 32
	Interrupt: pin A routed to IRQ 18
	Region 0: I/O ports at a800 [size=16]
	Region 1: I/O ports at a400 [size=16]
	Region 2: I/O ports at a000 [size=16]
	Region 3: I/O ports at 9800 [size=16]
	Region 4: I/O ports at 9400 [size=32]
	Region 5: I/O ports at 9000 [size=256]
	[virtual] Expansion ROM at 20020000 [disabled] [size=64K]
	Capabilities: [e0] Power Management version 2
		Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA  
PME(D0-,D1-,D2-,D3hot-,D3cold-)
		Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
	Kernel driver in use: sata_via
00: 06 11 49 32 07 00 90 02 50 00 04 01 00 20 00 00
10: 01 a8 00 00 01 a4 00 00 01 a0 00 00 01 98 00 00
20: 01 94 00 00 01 90 00 00 00 00 00 00 06 11 49 32
30: 00 00 00 00 e0 00 00 00 00 00 00 00 0a 01 00 00
40: 33 03 f1 44 0e af 00 00 00 00 00 03 00 00 00 00
50: 00 00 04 00 00 00 00 00 00 10 10 00 05 00 20 00
60: 00 00 ff ff 00 00 00 00 00 00 00 00 00 00 ff ff
70: 00 00 00 00 01 f0 00 00 01 00 01 00 11 00 00 00
80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
a0: 0b f2 c9 35 10 ac c0 00 a8 a8 a8 a8 ff 00 b6 b6
b0: 0f 0f 0f 0f 34 00 00 00 00 00 20 00 00 00 00 00
c0: 00 02 00 00 00 00 00 00 00 02 00 00 00 00 00 00
d0: 02 01 00 00 00 00 00 00 02 01 00 00 00 00 00 00
e0: 01 00 02 00 00 00 00 00 50 01 49 32 06 11 49 32
f0: 00 00 70 00 00 00 00 00 00 00 00 00 00 00 00 00

flashrom v0.9.6.1-r1564 on Linux 2.6.32-5-686 (i686)
flashrom is free software, get the source code at http://www.flashrom.org

flashrom was built with libpci 3.1.7, GCC 4.4.5, little endian
Command line (3 args): ./flashrom -p atavia -V
Calibrating delay loop... OS timer resolution is 1 usecs, 261M loops per  
second, delay more than 10% too short (got 87% of expected delay),  
recalculating... 296M loops per second, 10 myus = 10 us, 100 myus = 98 us,  
1000 myus = 986 us, 10000 myus = 9789 us, 4 myus = 5 us, OK.
Initializing atavia programmer
Found "VIA VT6421A" (1106:3249, BDF 00:0f.0).
===
This PCI device is UNTESTED. Please report the 'flashrom -p xxxx' output
to flashrom at flashrom.org if it works for you. Please add the name of your
PCI device to the subject. Thank you for your help!
===
Requested BAR is ROM
Error: No supported PCI device found.

HTH,
Roy