[flashrom] Other Log, have information relevant

[Jose Luis León]

I did modify the file patch and replace this:
+ .name = "LE25FU406C/LE25U40CMC",

for this:
+ .name = "LE25FU406C",

and execute the command:
flashrom -p serprog:dev=/dev/ttyACM0:115200 -V -c LE25FU406C -o log2.txt

and show information interesting

Link in choapp
http://chopapp.com/#f81lkgy7

attach of log:
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.flashrom.org/pipermail/flashrom/attachments/20151109/a013cccf/attachment.html>
-------------- next part --------------
flashrom v0.9.8-r1888 on Linux 3.19.0-25-generic (i686)
flashrom was built with libpci 3.2.1, GCC 4.8.4, little endian
Command line (7 args): flashrom -p serprog:dev=/dev/ttyACM0:115200 -V -c LE25FU406C -o log2.txt
Calibrating delay loop... OS timer resolution is 2 usecs, 787M loops per second, 10 myus = 11 us, 100 myus = 175 us, 1000 myus = 1108 us, 10000 myus = 11352 us, 8 myus = 17 us, OK.
Initializing serprog programmer
Baud rate is 115200 now.
serprog: connected - attempting to synchronize
...
serprog: Synchronized
serprog: Interface version ok.
serprog: Bus support: parallel=off, LPC=off, FWH=off, SPI=on
serprog: Maximum write-n length is 1013
serprog: Maximum read-n length is 23552
serprog: Programmer name is "frser-duino"
serprog: Serial buffer size is 1020
serprog: operation buffer size is 12
serprog: Output drivers enabled
The following protocols are supported: SPI.
Probing for Sanyo LE25FU406C, 512 kB: RDID byte 0 parity violation. probe_spi_rdid_generic: id1 0xff, id2 0xffff
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.
serprog: Output drivers disabled