Hi,<br><br>I have a Asus motherboard (p7p55d-e pro) with (I believe) an onboard Marvell 9120 Sata 3 controller.  I also have an add on  card Sata controller with a Marvell 9123 chip.  When I updated my firmware, both devices were found and updated but upon reboot the "on board" Marvell Controller is bricked.  It no longer appears in the boot up/bios sequence.<br>

<br>I'm looking for a way to flash the chip back preferably in circuit.  Is this something flashrom can do?  The Marvell Flash device is macronix MX25L4005A.<br><br>Thanks,<br>Pete<br><br> I'm pretty sure this is the controller that's not responding<br>

<br>0a:00.1 IDE interface [0101]: Device [1b4b:91a4] (rev 11) (prog-if 8f [Master SecP SecO PriP PriO])<br>    Subsystem: Device [1b4b:91a4]<br>    Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-<br>

    Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-<br>    Interrupt: pin B routed to IRQ 16<br>    Region 0: I/O ports at dc00 [size=8]<br>    Region 1: I/O ports at d880 [size=4]<br>

    Region 2: I/O ports at d800 [size=8]<br>    Region 3: I/O ports at d480 [size=4]<br>    Region 4: I/O ports at d400 [size=16]<br>    Region 5: Memory at f7effc00 (32-bit, non-prefetchable) [size=16]<br>    Expansion ROM at f7ee0000 [disabled] [size=64K]<br>

    Capabilities: <access denied><br>00: 4b 1b a4 91 03 01 10 00 11 8f 01 01 08 00 80 00<br>10: 01 dc 00 00 81 d8 00 00 01 d8 00 00 81 d4 00 00<br>20: 01 d4 00 00 00 fc ef f7 00 00 00 00 4b 1b a4 91<br>30: 00 00 ee f7 40 00 00 00 00 00 00 00 0a 02 00 0<br>