<div>
<div>
Dear Developer!</div>
<div>
</div>
<div>
Heres the outputs of the Abit AN-M2HD board. I cant wrote the Winbod chip.</div>
<div>
</div>
<div>
<div>
<em>xubuntu@xubuntu:~/Desktop$ sudo flashrom -p internal -E</em></div>
<div>
<em>flashrom v0.9.6.1-r1563 on Linux 3.13.0-8-generic (x86_64)</em></div>
<div>
<em>flashrom is free software, get the source code at http://www.flashrom.org</em></div>
<div>
</div>
<div>
<em>Calibrating delay loop... OK.</em></div>
<div>
<em>Found chipset "NVIDIA MCP67". Enabling flash write... This chipset is not really supported yet. Guesswork...</em></div>
<div>
<em>Please send the output of "flashrom -V" to flashrom@flashrom.org with</em></div>
<div>
<em>your board name: flashrom -V as the subject to help us finish support for your</em></div>
<div>
<em>chipset. Thanks.</em></div>
<div>
<em>OK.</em></div>
<div>
<em>Found Winbond flash chip "W39V040B" (512 kB, LPC) at physical address 0xfff80000.</em></div>
<div>
<em>Erasing and writing flash chip... Erase/write done.</em></div>
<div>
<em>xubuntu@xubuntu:~/Desktop$ sudo flashrom -p internal -w JN.BIN </em></div>
<div>
<em>flashrom v0.9.6.1-r1563 on Linux 3.13.0-8-generic (x86_64)</em></div>
<div>
<em>flashrom is free software, get the source code at http://www.flashrom.org</em></div>
<div>
</div>
<div>
<em>Calibrating delay loop... OK.</em></div>
<div>
<em>Found chipset "NVIDIA MCP67". Enabling flash write... This chipset is not really supported yet. Guesswork...</em></div>
<div>
<em>Please send the output of "flashrom -V" to flashrom@flashrom.org with</em></div>
<div>
<em>your board name: flashrom -V as the subject to help us finish support for your</em></div>
<div>
<em>chipset. Thanks.</em></div>
<div>
<em>OK.</em></div>
<div>
<em>Found Winbond flash chip "W39V040B" (512 kB, LPC) at physical address 0xfff80000.</em></div>
<div>
<em>Flash image seems to be a legacy BIOS. Disabling coreboot-related checks.</em></div>
<div>
<em>Reading old flash chip contents... done.</em></div>
<div>
<em>Erasing and writing flash chip... writing sector at 0x7fd89382a000 failed!</em></div>
<div>
<em>Reading current flash chip contents... done. writing sector at 0x7fd89382a000 failed!</em></div>
<div>
<em>FAILED!</em></div>
<div>
<em>Uh oh. Erase/write failed. Checking if anything changed.</em></div>
<div>
<em>Good. It seems nothing was changed.</em></div>
<div>
<em>Writing to the flash chip apparently didn't do anything.</em></div>
<div>
<em>This means we have to add special support for your board, programmer or flash chip.</em></div>
<div>
<em>Please report this on IRC at irc.freenode.net (channel #flashrom) or</em></div>
<div>
<em>mail flashrom@flashrom.org!</em></div>
<div>
<em>-------------------------------------------------------------------------------</em></div>
<div>
<em>You may now reboot or simply leave the machine running.</em></div>
<div>
<em>xubuntu@xubuntu:~/Desktop$ sudo flashrom -p internal -V</em></div>
<div>
<em>flashrom v0.9.6.1-r1563 on Linux 3.13.0-8-generic (x86_64)</em></div>
<div>
<em>flashrom is free software, get the source code at http://www.flashrom.org</em></div>
<div>
</div>
<div>
<em>flashrom was built with libpci 3.1.9, GCC 4.7.1, little endian</em></div>
<div>
<em>Command line (3 args): flashrom -p internal -V</em></div>
<div>
<em>Calibrating delay loop... OS timer resolution is 1 usecs, 388M loops per second, delay more than 10% too short (got 65% of expected delay), recalculating... 494M loops per second, delay more than 10% too short (got 84% of expected delay), recalculating... 509M loops per second, delay more than 10% too short (got 86% of expected delay), recalculating... 457M loops per second, delay more than 10% too short (got 77% of expected delay), recalculating... 511M loops per second, delay loop is unreliable, trying to continue 10 myus = 9 us, 100 myus = 86 us, 1000 myus = 852 us, 10000 myus = 8542 us, 4 myus = 5 us, OK.</em></div>
<div>
<em>Initializing internal programmer</em></div>
<div>
<em>No coreboot table found.</em></div>
<div>
<em>DMI string system-manufacturer: "."</em></div>
<div>
<em>DMI string system-product-name: "."</em></div>
<div>
<em>DMI string system-version: "Unknow"</em></div>
<div>
<em>DMI string baseboard-manufacturer: "http://www.abit.com.tw/"</em></div>
<div>
<em>DMI string baseboard-product-name: "AN-M2HD(MCP68)"</em></div>
<div>
<em>DMI string baseboard-version: "1.x "</em></div>
<div>
<em>DMI string chassis-type: "Desktop"</em></div>
<div>
<em>Found chipset "NVIDIA MCP67" with PCI ID 10de:0548. Enabling flash write... This chipset is not really supported yet. Guesswork...</em></div>
<div>
<em>ISA/LPC bridge reg 0x8a contents: 0x00, bit 6 is 0, bit 5 is 0</em></div>
<div>
<em>Flash bus type is LPC</em></div>
<div>
<em>Found SMBus device 10de:0542 at 00:01:1</em></div>
<div>
<em>MCP SPI BAR is at 0xfec80000</em></div>
<div>
<em>Strange. MCP SPI BAR is valid, but chipset apparently doesn't have SPI enabled.</em></div>
<div>
<em>Please send the output of "flashrom -V" to flashrom@flashrom.org with</em></div>
<div>
<em>your board name: flashrom -V as the subject to help us finish support for your</em></div>
<div>
<em>chipset. Thanks.</em></div>
<div>
<em>OK.</em></div>
<div>
<em>The following protocols are supported: LPC.</em></div>
<div>
<em>Probing for AMIC A49LF040A, 512 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for Atmel AT49LH002, 256 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for PMC Pm49FL002, 256 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for PMC Pm49FL004, 512 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for SST SST49LF020, 256 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for SST SST49LF020A, 256 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for SST SST49LF040, 512 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for SST SST49LF040B, 512 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for SST SST49LF080A, 1024 kB: Chip lacks correct probe timing information, using default 10mS/40uS. probe_jedec_common: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for SST SST49LF160C, 2048 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for ST M50FLW040A, 512 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for ST M50FLW040B, 512 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for ST M50FLW080A, 1024 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for ST M50FLW080B, 1024 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for ST M50LPW116, 2048 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for Winbond W39V040A, 512 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for Winbond W39V040B, 512 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Found Winbond flash chip "W39V040B" (512 kB, LPC) at physical address 0xfff80000.</em></div>
<div>
<em>Lockout bits:</em></div>
<div>
<em>Hardware bootblock locking (#TBL) is active.</em></div>
<div>
<em>Hardware remaining chip locking (#WP) is active..</em></div>
<div>
<em>Probing for Winbond W39V040C, 512 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Probing for Winbond W39V080A, 1024 kB: probe_jedec_common: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content</em></div>
<div>
<em>Probing for Winbond W49V002A, 256 kB: probe_jedec_common: id1 0xda, id2 0x54</em></div>
<div>
<em>Found Winbond flash chip "W39V040B" (512 kB, LPC).</em></div>
<div>
<em>No operations were specified.</em></div>
<div>
<em>Restoring PCI config space for 00:01:0 reg 0x6d</em></div>
<div>
<em>Restoring PCI config space for 00:01:0 reg 0x90</em></div>
<div>
<em>Restoring PCI config space for 00:01:0 reg 0x8c</em></div>
<div>
<em>Restoring PCI config space for 00:01:0 reg 0x88</em></div>
<div>
<em>xubuntu@xubuntu:~/Desktop$ </em></div>
</div>
<div>
</div>
<div>
Thans</div>
</div>
<div>
</div>