<div dir="ltr">Hello I tested for cleaning work, reading, writing, memory AT25DF161 using Bus Pirate v4.<div>Used:</div><div>flashrom v0.9.6.1-r1704 on Windows 6.1 (x86)</div><div>flashrom was built with GCC 4.7.2, little endian</div>

<div><div><div>Baud rate is 115200.</div><div>Detected Bus Pirate hardware v4</div><div>Detected Bus Pirate firmware 6.2 ("v6.2-beta1")</div><div>Using SPI command set v2.</div><div>SPI speed is 8MHz</div><div>
Raw bitbang mode version 1</div>
<div>Raw SPI mode version 1</div><div>The following protocols are supported: SPI.</div><div>Probing for Atmel AT25DF161, 2048 kB: probe_spi_rdid_generic: id1 0x1f, id2 0x4602</div><div>Found Atmel flash chip "AT25DF161" (2048 kB, SPI) on buspirate_spi.</div>

</div><div><div>Ignoring security lockdown (if present)</div><div>Ignoring status register byte 2</div><div>Chip status register is 0x0c.</div><div>Chip status register: Sector Protection Register Lock (SRPL) is not set</div>

<div>Chip status register: Bit 6 is not set</div><div>Chip status register: Erase/Program Error (EPE) is not set</div><div>Chip status register: WP# pin (WPP) is asserted</div><div>Chip status register: Software Protection Status (SWP): all sectors are protected</div>

<div>Chip status register: Write Enable Latch (WEL) is not set</div><div>Chip status register: Write In Progress (WIP/BUSY) is not set</div><div>===</div></div><div><br></div><div><div>Initially, there was a problem with the use of long cables (> 20 cm). </div>

<div>After verification of the firmware did not pass. </div><div>Replaced wires from Bus Pirate at length (10cm), all turned out. Many thanks for the utility. I think that you can remove the status UNTESTED with this chip. Thank you again. </div>

</div><div>I think it is reasonable to point out the page on the wiki that the length of wire for the Bus Pirate is very desirable <= 10 cm, to avoid many mistakes. This saves the trouble of starting recording, reading chips.<br>

</div><div><br></div><div>Sorry for my bad english, I'm from Russia.<br></div><div><br></div>-- <br><div dir="ltr">С уважением Алексей<br></div>
</div></div>