sudo /usr/sbin/flashrom -p internal -V
flashrom v0.9.7-r1711 on Linux 3.17.4-1-desktop (x86_64)                                                                                                                                                                         
flashrom is free software, get the source code at http://www.flashrom.org                                                                                                                                                        
                                                                                                                                                                                                                                 
flashrom was built with libpci 3.2.1, GCC 4.8.3 20140627 [gcc-4_8-branch revision 212064], little endian                                                                                                                         
Command line (3 args): /usr/sbin/flashrom -p internal -V                                                                                                                                                                         
Calibrating delay loop... OS timer resolution is 1 usecs, 2993M loops per second, 10 myus = 10 us, 100 myus = 109 us, 1000 myus = 1001 us, 10000 myus = 10007 us, 4 myus = 5 us, OK.                                             
Initializing internal programmer                                                                                                                                                                                                 
No coreboot table found.                                                                                                                                                                                                         
DMI string system-manufacturer: "                                "
DMI string system-product-name: "                                "
DMI string system-version: "                        "
DMI string baseboard-manufacturer: "Intel Corporation"
DMI string baseboard-product-name: "DP35DP"
DMI string baseboard-version: "AAD81073-207"
DMI string chassis-type: "Unknown"
DMI chassis-type is not specific enough.
W836xx enter config mode worked or we were already in config mode. W836xx leave config mode had no effect.
Active config mode, unknown reg 0x20 ID: f1.
Please send the output of "flashrom -V" to 
flashrom@flashrom.org with W836xx: your board name: flashrom -V
as the subject to help us finish support for your Super I/O. Thanks.
========================================================================
WARNING! You may be running flashrom on an unsupported laptop. We could
not detect this for sure because your vendor has not setup the SMBIOS
tables correctly. You can enforce execution by adding
'-p internal:laptop=this_is_not_a_laptop' to the command line, but
please read the following warning if you are not sure.

Laptops, notebooks and netbooks are difficult to support and we
recommend to use the vendor flashing utility. The embedded controller
(EC) in these machines often interacts badly with flashing.
See the manpage and http://www.flashrom.org/Laptops for details.

If flash is shared with the EC, erase is guaranteed to brick your laptop
and write may brick your laptop.
Read and probe may irritate your EC and cause fan failure, backlight
failure and sudden poweroff.
You have been warned.
========================================================================
Aborting.
Error: Programmer initialization failed.