<div dir="ltr">Thank you very much for your response. I will check the link and hope to manage and enable it. One last question: if a board recognizes a 512kb chip is it normal to not recognize the above described ( <span style="color:rgb(80,0,80);font-size:12.8000001907349px">SST 49LF008A )</span> 1Mb chip ??? I have a board with which i could do the flash procedure, it is fully supported by flashrom, flash chip, chipset, board, but it doesn;t seem to find the chip i want to flash. The original 512 Kb chip it's listed when i run flashrom, but when i change chips with the 1Mb one and run again flashrom the new chip it's not recognized...<div><br></div><div>Thank you</div></div><div class="gmail_extra"><br><div class="gmail_quote">On Wed, Feb 18, 2015 at 11:26 PM, Stefan Tauner <span dir="ltr"><<a href="mailto:stefan.tauner@alumni.tuwien.ac.at" target="_blank">stefan.tauner@alumni.tuwien.ac.at</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><span class="">On Wed, 18 Feb 2015 16:26:35 +0300<br>
"nicolae788 ." <<a href="mailto:nicolae788@gmail.com">nicolae788@gmail.com</a>> wrote:<br>
<br>
> Hello,<br>
><br>
> I am trying to write a chip SST 49LF008A in a P5W-DH board. This is not the<br>
> original chip of the board, it's a hot flash. The flashrom properly detects<br>
> the ICH7R chipset and the chip described above, but can only read from it<br>
> no erase or write. The problem is that it does not enable the TBL pin on<br>
> the chip, it stays low. I checked if the pin can be enabled by using the<br>
> onboard flash utility from whitin the original BIOS of this board an i get<br>
> a high on that pin ( +3.3V ) so it means that the chipset it's doing the<br>
> work if properly enabled.<br>
</span>> […]<br>
<span class="">> Can someone please instruct me on how to proceed further? Thank you very<br>
> much for your kindness.<br>
><br>
<br>
</span>Hi,<br>
<br>
as the name suggests a board enable is rather board-specific. It is<br>
usually required to toggle a GPIO pin of the southbridge that is<br>
connected to the TBL or #WP pin of the flash chip. What needs to be<br>
done is actually encoded in the BIOS image (not the flash tool) so it<br>
can be recovered by reverse engineering. See<br>
<a href="http://flashrom.org/Board_Enable" target="_blank">http://flashrom.org/Board_Enable</a> for more details.<br>
<span class="HOEnZb"><font color="#888888">--<br>
Kind regards/Mit freundlichen Grüßen, Stefan Tauner<br>
</font></span></blockquote></div><br></div>