<div dir="ltr"><div>Base Board Information</div><div>        Manufacturer: Gigabyte Technology Co., Ltd.</div><div>        Product Name: J1900N-D3V</div><div>        Rev 1.x<br><br></div><div>As 0.9.8 this chip is still on test, I could flash It. Unfortunately I didn't enable the log, so I execute again with the log feature enabled. It refuses to flash because the content is the same, but hopefully the information that you need is still there.<br><br></div><div>Have fun.<br></div><div><br></div><div style="margin-left:40px"><span style="font-family:monospace,monospace"># flashrom --programmer internal<br>flashrom v0.9.8-r1888 on Linux 3.16.7-21-desktop (x86_64)<br>flashrom is free software, get the source code at <a href="http://www.flashrom.org">http://www.flashrom.org</a><br><br>Calibrating delay loop... OK.<br>Active config mode, unknown reg 0x20 ID: 86.<br>Please send the output of "flashrom -V -p internal" to <br><a href="mailto:flashrom@flashrom.org">flashrom@flashrom.org</a> with W836xx: your board name: flashrom -V<br>as the subject to help us finish support for your Super I/O. Thanks.<br>Found chipset "Intel Bay Trail".<br><b>Enabling flash write... OK.<br>Found Macronix flash chip "MX25U6435E/F" (8192 kB, SPI) mapped at physical address 0x00000000ff800000.</b><br>===                                                                                                                                                                                                                                                                            <br>This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE<br>The test status of this chip may have been updated in the latest development<br>version of flashrom. If you are running the latest development version,<br>please email a report to <a href="mailto:flashrom@flashrom.org">flashrom@flashrom.org</a> if any of the above operations<br>work correctly for you with this flash chip. Please include the flashrom log<br>file for all operations you tested (see the man page for details), and mention<br>which mainboard or programmer you tested in the subject line.<br>Thanks for your help!                                                                                                                                                                                                                                                          </span><br></div></div>