Difference between revisions of "Connections"

From flashrom
Jump to: navigation, search
(Connect to a clip)
Line 3: Line 3:
  
 
== Connect to a clip ==
 
== Connect to a clip ==
Some programmers, like the [[Bus_Pirate]] have pin connectors on them.
+
* If your programmer has a pin connector, and that you want to avoid soldering, you can use'''Short''' Jumper Wires to connect it to a clip.
* '''Short''' Jumper Wires can be used to connect the programmer to the clip.
 
  
 
== Common issues ==
 
== Common issues ==
 
* Wires length, connection quality: Long wires, and bad connection can create some issues, so avoid them. If you can't and if you're flash chip is SPI, then lowering the SPI clock can make it work in some cases. Many programmers do support such option(Called spispeed with most of them, or divisor with ft2232_spi).
 
* Wires length, connection quality: Long wires, and bad connection can create some issues, so avoid them. If you can't and if you're flash chip is SPI, then lowering the SPI clock can make it work in some cases. Many programmers do support such option(Called spispeed with most of them, or divisor with ft2232_spi).
 
* When soldering wires, the wire tend to break near the soldering point, to avoid such issue, you have to prevent the wires from bending near the soldering point. To do that [https://en.wikipedia.org/wiki/Heat-shrink_tubing Heat-shrink_tubing] or similar methods can be used.
 
* When soldering wires, the wire tend to break near the soldering point, to avoid such issue, you have to prevent the wires from bending near the soldering point. To do that [https://en.wikipedia.org/wiki/Heat-shrink_tubing Heat-shrink_tubing] or similar methods can be used.

Revision as of 17:11, 12 April 2015

  • Using ISP requires some means to connect the external programmer to the flash chip.
  • Note that some external flasher(like the Openmoko debug board) do requires some soldering to connect it to the flash chip, while some other don't(The Bus_Pirate Has a pin connector on it).

Connect to a clip

  • If your programmer has a pin connector, and that you want to avoid soldering, you can useShort Jumper Wires to connect it to a clip.

Common issues

  • Wires length, connection quality: Long wires, and bad connection can create some issues, so avoid them. If you can't and if you're flash chip is SPI, then lowering the SPI clock can make it work in some cases. Many programmers do support such option(Called spispeed with most of them, or divisor with ft2232_spi).
  • When soldering wires, the wire tend to break near the soldering point, to avoid such issue, you have to prevent the wires from bending near the soldering point. To do that Heat-shrink_tubing or similar methods can be used.