From flashrom
Revision as of 11:48, 12 June 2011 by Stefanct (talk | contribs)
Jump to navigation Jump to search

This wiki is retired

Our website is, instructions on how to add or update documentation are here

All wiki content available in read-only mode at

In-System Programming (ISP) sometimes also called in situ programming is used to describe the procedure of writing a flash chip while it is (already/still) attached to the circuit it is to be used with. Of course any normal "BIOS flash" procedure is a kind of ISP but when we refer to ISP we usually mean something different: programming a flash chip by external means while it is mounted on a motherboard.

This is usually done with SPI chips only. Some mainboards have a special header for this (usually named ISP) and there should be no problem with accessing the chip then as long as the wires are not too long.

If there is no special header then using a special SO(IC) clip is an easy and reliable way to attach an external programmer. They are produced by different vendors (e.g. Pomona, 3M) and are available from many distributors (i got mine from distrelec) for 20-50$/€.

Pomona 8-pin SOIC clip with attached jumper wires.


  1. Wires are too long.
  2. The impedances of the wires/traces do not match the impedances of the input pins (of either the circuit/chip on the mainboard or the external programmer). Try using shorter wires, adding small (<100 Ohm) series resistors or parallel capacitors (<20pF) as near as possible to the input pins (this includes also the MISO line which ends near the programmer) and/or ask someone who has experience with high frequency electronics.
  3. The SPI bus is not isolated enough. Often parts of the chipset are powered on partially (by the voltage supplied via the Vcc pin of the flash chip).
    • Try powering up the board normally and holding it in reset (e.g. use a jumper instead of the reset push button).
    • Some chipsets (e.g. Intel ICHs/PCHs) have edge triggered resets. In this case holding them in reset will not work. This is especially a problem with Intel chipsets because they contain an EC (named ME by Intel), which uses the flash (r/w!). In this cases you can trigger the reset line in short intervals. For example by connecting it to the chip select (CS) line of the SPI bus or a dedicated clock signal from the programmer. This should not be too fast though! Reset lines usually require pulses with a minimum duration.