[flashrom] tested boardenable/flashing on iBase:MB899

Bernhard M. Wiedemann bernhard at lsmod.de
Tue Apr 20 12:01:53 CEST 2010



# flashrom -p internal:boardenable=force -m iBASE:MB899 -w coreboot.rom 
flashrom v0.9.1-runknown on Linux 2.6.18-skas3-v9-pre9-default (i686), built with libpci 2.2.4-pre4, GCC 3.4.6 (Debian 3.4.6-5)
No coreboot table found.
Found chipset "Intel ICH7M", enabling flash write... OK.
This chipset supports the following protocols: FWH.
NOTE: Running an untested board enable procedure.
Please report success/failure to flashrom at flashrom.org.
Disabling flash write protection for board "iBASE MB899"... 
Intel ICH LPC Bridge: Raising GPIO26.
OK.
Calibrating delay loop... OK.
Found chip "SST SST49LF004A/B" (512 KB, FWH) at physical address 0xfff80000.
Writing flash chip... Erasing flash chip... SUCCESS.
Programming page: DONE!ss: 0x0007f000
COMPLETE.
Verifying flash... VERIFIED.          


-- 
Bernhard M. Wiedemann
software engineer




More information about the flashrom mailing list